Search:

Durasolid Carrier Bearing Puller – A Boon for Differential Installers

DURASOLID differential carrier bearing puller is a specialty tool that every automotive differential installer must have. The original as well as other branded differential bearings are quite expensive and often in short supply. Saving the same for reuse becomes quite important to save some money in these bad times.

Differential installers often face situations where after having set up the gears and replacing bearings they find that the shims under carrier bearings need to be changed to adjust the backlash. The conventional tools would end up in damaging the bearings or the seal surface and to save the same you have no choice but to live with the problem.

Now the installers don’t need to compromise or be afraid of damaging the carrier bearing if they own a Durasolid carrier bearing puller kit as the clamshell design won’t let the bearings damage while pulling them out and also save your expensive differential locker or carrier from damaging.

There were times when these differential carrier bearing pullers used to be very expensive and thus unaffordable and the automotive differential installers had no choice but to use the conventional tools or at the most commercial bearing pullers to pull the bearings from differential carriers, air lockers or pinions and end up spending too much of their expensive time and also damaging the carrier bearings or the seal surface in case of air lockers. Differential Installers who could not afford to buy the Clam shell design bearing pullers used to get it on rent as high as $100.

DURASOLID upon realizing this fact launched their clamshell design bearing puller in the range of $200.

DURASOLID carrier bearing puller further comes in two versions :

DBP DFF001 works on most standard size carrier bearing bearings / pinion bearings on differentials up to & including Dana 70, Dana 70 HD and Ford 10.25”.

DBP DFF002 is to save money for those who do not work on Dana 70 HD, DANA 80 and FORD 10.25

The parts of the bearing puller that undergo heavy loads or wear and tear are made from alloy steel and heat treated to give a very long life. Majority of the parts are powder coated for good aesthetics and corrosion resistance. A sleek stand takes care of proper storage of all parts of this bearing puller.

Most of the light duty differential carriers do not have access or relief cut under the seating face of the bearing cone or the relief cut is too small and conventional bearing pullers mostly end up damaging the bearing and sometimes even the differential carrier / Air Locker ground face or the seal housing. The improved clamshell design of this bearing puller easily pulls out the carrier bearings from most of the light duty differential carriers and does not let the differential bearings damage.

While you enjoy this special tool at special price, DURASOLID is committed to bring to you an affordable range of differential service / installation equipments in days to come and make your work easy.

Article Source: http://www.ezinearticles.mk

Founded in 2008 Durasolid expertise in supplying various Differential Auto Parts like Ford 9” full spools, Ford 9 inch full Spools, spindles, front Axle shafts, rear axle shafts, dana 60 axle,

Please Rate this Article

Not yet Rated